Right Angle Prism BK7 25.4mm λ/4 AL Coat Legs

RPB4-25.4-550

Right-angle prism can be used as a substitute for the mirror. Independent even without a special holder, and since the choice of a variety of installation methods, it is useful if you want to reduce the size of the device. In addition, with very high accuracy and precision angle of the prism surface, it can also be used by directly bonding it to machined parts.
◦RPB1 to 3 are used as a substitute for the mirror reflection of the slope. RPB1 is coated with anti-reflection coating with two surfaces which the light is incident and emitted by using the critical angle prism reflection of the slope and the surface. RPB2 are coated with reflective coating (Al+MgF2) on the surface of slope. RPB3 is the product which does not pass through the light reflected by the inclined surface of the interior of the prism, and there are three types.
◦RPB4 can be used when you want to use the reflection of the two surfaces sandwiching the apex angle (right angle). RPB4 can be used as to when observe two opposite directions at the same time, or as a prototype orthogonal basis and so on.
◦RPB5 are used in applications where light back at the same angle as the incident light with respect to the horizontal direction. And double pass interferometer is used in (such as self-correlator) auto correlator.
More Information
Name Right Angle Prism BK7 25.4mm λ/4 AL Coat Legs
Weight 0.0210kgs
Standard Coatings Available No
Guide
  • For custom sizes and wavelengths not listed on-line or in our catalog please contact our Sales Division with your requests.
  • Prisms are also available uncoated.
  • WEB Reference Catalog Code/W3124
Remark -
Attention
  • A dimension measured is slightly shorter than the catalog size because it contains chamfer dimension. Dimensional tolerances are defined by the sides of the triangle with the slope and two bottom surface.
  • If the light is incident on the slope from the air side, most of the light through the prism side and it reflects only part of the light.
  • If the incident light at an incident angle of 41 degrees or less (less than the critical angle) from the side of the glass which is no coating on the surface, will not be total reflection but part of the light is transmitted through the air side.
  • Sometimes when dirt or fingerprints on the surface with no coating, total reflection will not happen any more than the critical angle. Do not contact anything on the no coated surface.
  • Please use RPB5 in the range of 0±5.7 degrees for the slope. Beyond this range, it will not be totally reflected.
  • RPB2 are also reflected at an angle smaller than the critical angle by Al coating, but the reflectance will be lower to 12% less than the RPB1.
Length 25.4mm
Material BK7
Material BK7 (Refractive index nd=1.517)
Surface flatness of substrate λ/4
Angle tolerance ±1′ (90°or 45°)
Coating Antireflection Coating or Al+MgF2 (Prtected coating)
Wavelength Range 400 - 700nm
Surface Quality <br> (Scratch-Dig) 40-20
A=B 25.4mm
Laser Damage Threshold<sup>*</sup> 0.25J/cm2
Availability From stock
In stock
SKU
RPB4-25.4-550
$183.00

Delivery in : in stock

Right-angle prism can be used as a substitute for the mirror. Independent even without a special holder, and since the choice of a variety of installation methods, it is useful if you want to reduce the size of the device. In addition, with very high accuracy and precision angle of the prism surface, it can also be used by directly bonding it to machined parts.

Resources & Downloads