Hand-Held Laser Checker
LCP-33
Compact and lightweight power meter for checking laser output that is small enough to fit into a pocket or tool kit.
◦Press the Sample/Hold button to power on, center the laser beam on the sensor for two seconds or more while holding down the button. Release the button to see a measurement of the power.
◦It will automatically power off after 10 seconds when a measurement is completed.
◦Maximum power density is 30W/cm2 when the built-in ND attenuator is used, and 0.5W/cm2 when the attenuator is not used.
◦Sensor disk is made of silicon and has an 8mm aperture.
◦Battery life is 180,000 measurements at 12 sec/sample. The built-in lithium cell is not replaceable.
◦As overload warning, "---" will be displayed on the LCD screen with beep tone.
◦Microprocessor controlled with wavelength correction, auto-range (μW or mW), attenuator, power overload warning, and auto-stop functions.
◦It will automatically power off after 10 seconds when a measurement is completed.
◦Maximum power density is 30W/cm2 when the built-in ND attenuator is used, and 0.5W/cm2 when the attenuator is not used.
◦Sensor disk is made of silicon and has an 8mm aperture.
◦Battery life is 180,000 measurements at 12 sec/sample. The built-in lithium cell is not replaceable.
◦As overload warning, "---" will be displayed on the LCD screen with beep tone.
◦Microprocessor controlled with wavelength correction, auto-range (μW or mW), attenuator, power overload warning, and auto-stop functions.
| Name | Hand-Held Laser Checker |
|---|---|
| Weight | 0.0500kgs |
| Standard Coatings Available | No |
| Guide | - |
| Attention |
|
| Wavelength Range | 400 - 1064nm |
| Wavelength | 400 - 1064nm |
| Power Range | 0.5μW - 1W |
| Outer Dimensions | 168×24×20mm |
In stock
SKU
LCP-33
€594.60
Customize product
Compact and lightweight power meter for checking laser output that is small enough to fit into a pocket or tool kit.