UV-NIR, In-Line Beam Collimation Checkers, CMOS Camera, 355-1100nm

SPUVNIR-1.5-CS

Skip to the beginning of the images gallery

A beam collimation checker for small beam diameter UV light that can be used with low coherence light.

The state of the beam can be evaluated only by inserting the unit into the optical path, the troubles of optical alignment and the time can be greatly reduced, and a higher quality light beam can be obtained. Can be used with small beam diameter (1.5mm or more ). Corresponds to the wavelength of the light source from UV to near infrared. (4355nm to 1100 nm) It is a composite product of collimation checker main unit (including USB camera) and USB 3.0 cable (1.5 m) and can be used immediately after purchase. * PC will be prepared by customers.

More Information

More Information
Name	UV-NIR, In-Line Beam Collimation Checkers, CMOS Camera, 355-1100nm
Weight	0.0050kgs
Guide	Please download and install Automated Collimation Measurement Software (OSCAMS) from our website. Post is not included. Please purchase M6 threaded Post and Post stand from our catalog. The size of the M6 hole meets our standard. When post is prepared by customer, please make sure M6 thread length is less than 5 mm.
Attention	When inserting this product and optics into the laser beam path, there is a danger that the laser beam will be reflected towards the operator, so please observe safety precautions for the laser light (wearing laser safety goggles etc.). Even if this product is inserted into the laser beam path, the beam is not blocked and exits from the aperture, so please do not look into the laser beam path. Please use under the condition of incident beam power of 10 W/cm2 or less (reference value for 1064nm laser). Please use beam sampler (BS4) when exposing to a laser beam which exceeds. When the collimation checker is installed inclined with respect to the optical axis, clear interference fringes may not be observed in some cases. In such a case, by adjusting the collimation checker in the θz direction, an angle at which interference fringes can be clearly observed can be found.
Mounting Thread	M6
Wavelength Range	355 - 1100nm
Input Beam Diameter	1.5 mm
Material of Shearing Plate	N-BK7
Plate Thickness	0.5mm
Shearing Plate Flatness	Lambda/20
Fringe Spacing	0.37mm
Observing Device	CMOS Digital Camera, USB-3
Body Material	Aluminum (Black Anodized)
Max Beam Power	10W/cm2 or less (* Reference value: 1064nm laser)
Measurement Resolution Specs	Fringe rotation Angle: 0.1 Deg, Beam Curvature: 0.1 mm, Beam Converge/Diverge Angle: 0.01 mrad, Power(by wavelength): 0.1 mW

In stock

SKU

SPUVNIR-1.5-CS

A beam collimation checker for small beam diameter UV light that can be used with low coherence light.

UV-NIR, In-Line Beam Collimation Checkers, CMOS Camera, 355-1100nm

Resources & Downloads