Cage Alignment Holder

C30-AP-25.4

A plate that holds the optics of dia. 12.7mm in the 30mm Cage assembly and enables coarse position adjustment (movable range dia.1mm) in the plane. Loosen the two screws of the movable plate and adjust the position of the movable plate, then manually tighten and fix it.

Details

◦ The cage system has no distinction of up, down, left and right. Therefore, it is possible to place the holder in various orientations, which is convenient for constructing a three-dimensional optical system.

Weitere Informationen

Weitere Informationen
Name	Cage Alignment Holder
Gewicht	0.0050kgs
Guide	Please contact our Sales for methods to fix the cage system to other equipment and parts not included in the WEB catalog. For consultation of optical system using cage system please contact Sales.
Attention	If the rod is tightened too tightly or if the tightening force is greatly different depending on the location, the rod may not fit in other holders. Initially fix the rod lightly, after building the optical system, please tighten so that the force that fixes the rod is even in each holder. When configuring a large optical system or a long optical system, it may become distorted or become unstable due to vibration.
Primary material	Aluminum
Guide Rod Diameter (Spaceing between rod)	φ6mm （30x30mm）
Compatiblefixing screw	M26.25 P0.75
Adjustment Range	±1mm
Installation	Slide from the end of rods

Auf Lager

SKU

C30-AP-25.4

85,40 €